Loading this page…
A slow leak inside a wall or under a cabinet can feed mold for a long time before anyone sees it. We find the wet area, remove what has grown and dry the wall.

A burst pipe gets noticed the same day. A supply line that weeps a few drops an hour, a toilet seal that leaks into the subfloor or a drain that drips behind the dishwasher can go unseen for months, and in Florida's warm, humid air that is plenty of time for mold to take hold.
We read moisture across the wall, the cabinet floor and the baseboard to find the edge of the wet area. Then we open only what is damp, remove what has grown in a sealed work area and dry the cavity before it is closed up.
A moisture meter across the wall and floor shows how far the water has spread.
We show you where the water comes from so a plumber can repair it first.
Wet drywall, baseboard and cabinet floor come out behind plastic, with filtered air.
Fans and dehumidifiers run until the readings are normal, then we measure again.
Readings that show where the wall is wet and where it is dry.
Plastic sheeting, floor protection and filtered air so nothing spreads.
Damaged material taken out and the framing behind it cleaned.
The cavity dried and checked before any patching starts.
We find the leak and tell you exactly where it is. A licensed plumber repairs it, then we finish the cleanup and drying.
Only where the readings show the wall is wet. Dry drywall stays in place.
Often the boxes can, if the floor of the cabinet is replaced and the wall behind it is dried.
Tell us what you have seen or smelled and where. We will come out, measure and send a written estimate.